Struct esp32_hal::pac::uart0::idle_conf::R

pub struct R(_);

Register IDLE_CONF reader

Implementations

impl R

pub fn rx_idle_thrhd(&self) -> FieldReaderRaw<u16, u16>

Bits 0:9 - when receiver takes more time than this register value to receive a byte data. it will produce frame end signal for uhci to stop receiving data.

pub fn tx_idle_num(&self) -> FieldReaderRaw<u16, u16>

Bits 10:19 - This register is used to configure the duration time between transfers.

pub fn tx_brk_num(&self) -> FieldReaderRaw<u8, u8>

Bits 20:27 - This register is used to configure the num of 0 send after the process of sending data is done. it is active when txd_brk is set to 1.

Methods from Deref<Target = R<IDLE_CONF_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<IDLE_CONF_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<IDLE_CONF_SPEC>> for R

fn from(reader: R<IDLE_CONF_SPEC>) -> R

Converts to this type from the input type.