Struct esp32_hal::pac::sens::sar_meas_start1::R

pub struct R(_);

Register SAR_MEAS_START1 reader

Implementations

impl R

pub fn meas1_data_sar(&self) -> FieldReaderRaw<u16, u16>

Bits 0:15 - SAR ADC1 data

pub fn meas1_done_sar(&self) -> BitReaderRaw<bool>

Bit 16 - SAR ADC1 conversion done indication

pub fn meas1_start_sar(&self) -> BitReaderRaw<bool>

Bit 17 - SAR ADC1 controller (in RTC) starts conversion only active when reg_meas1_start_force = 1

pub fn meas1_start_force(&self) -> BitReaderRaw<bool>

Bit 18 - 1: SAR ADC1 controller (in RTC) is started by SW 0: SAR ADC1 controller is started by ULP-coprocessor

pub fn sar1_en_pad(&self) -> FieldReaderRaw<u16, u16>

Bits 19:30 - SAR ADC1 pad enable bitmap only active when reg_sar1_en_pad_force = 1

pub fn sar1_en_pad_force(&self) -> BitReaderRaw<bool>

Bit 31 - 1: SAR ADC1 pad enable bitmap is controlled by SW 0: SAR ADC1 pad enable bitmap is controlled by ULP-coprocessor

Methods from Deref<Target = R<SAR_MEAS_START1_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SAR_MEAS_START1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<SAR_MEAS_START1_SPEC>> for R

fn from(reader: R<SAR_MEAS_START1_SPEC>) -> R

Converts to this type from the input type.