Struct efm32gg11b_pac::efm32gg11b840::sdio::hostctrl1::R

pub struct R(_);

Register HOSTCTRL1 reader

Implementations

impl R

pub fn ledctrl(&self) -> LEDCTRL_R

Bit 0 - LED Control

pub fn dattranwd(&self) -> DATTRANWD_R

Bit 1 - Data Transfer Width 1-bit or 4-bit Mode

pub fn hsen(&self) -> HSEN_R

Bit 2 - High Speed Enable

pub fn dmasel(&self) -> DMASEL_R

Bits 3:4 - DMA Select

pub fn extdattranwd(&self) -> EXTDATTRANWD_R

Bit 5 - Extended Data Transfer Width

pub fn cdtstlvl(&self) -> CDTSTLVL_R

Bit 6 - Card Detect Test Level

pub fn cdsigdet(&self) -> CDSIGDET_R

Bit 7 - Card Detetct Signal Detection

pub fn sdbuspower(&self) -> SDBUSPOWER_R

Bit 8 - SD Bus Power

pub fn sdbusvoltsel(&self) -> SDBUSVOLTSEL_R

Bits 9:11 - SD Bus Voltage Select

pub fn hrdrst(&self) -> HRDRST_R

Bit 12 - Hardware Reset Signal

pub fn stopatblkgapreq(&self) -> STOPATBLKGAPREQ_R

Bit 16 - Stop at Block Gap Request

pub fn continuereq(&self) -> CONTINUEREQ_R

Bit 17 - Continue Request

pub fn rdwaitctrl(&self) -> RDWAITCTRL_R

Bit 18 - Read Wait Control

pub fn intatblkgap(&self) -> INTATBLKGAP_R

Bit 19 - Interrupt at Block Gap

pub fn spimode(&self) -> SPIMODE_R

Bit 20 - SPI Mode Enable

pub fn booten(&self) -> BOOTEN_R

Bit 21 - Boot Enable

pub fn altbooten(&self) -> ALTBOOTEN_R

Bit 22 - Alternate Boot Enable

pub fn bootackchk(&self) -> BOOTACKCHK_R

Bit 23 - Boot Ack Check

pub fn wkupevntenoncardint(&self) -> WKUPEVNTENONCARDINT_R

Bit 24 - Wakeup Event Enable on Card Interrupt

pub fn wkupevntenoncins(&self) -> WKUPEVNTENONCINS_R

Bit 25 - Wakeup Event Enable on SD Card Insertion

pub fn wkupevntenoncrm(&self) -> WKUPEVNTENONCRM_R

Bit 26 - Wakeup Event Enable on SD Card Removal

Methods from Deref<Target = R<HOSTCTRL1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<HOSTCTRL1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<HOSTCTRL1_SPEC>> for R

fn from(reader: R<HOSTCTRL1_SPEC>) -> Self

Converts to this type from the input type.