[−][src]Struct stm32g0::stm32g0x1::dmamux::dmamux_c6cr::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn dmareq_id(&mut self) -> _DMAREQ_IDW
[src]
Bits 0:7 - Input DMA request line selected
pub fn soie(&mut self) -> _SOIEW
[src]
Bit 8 - Interrupt enable at synchronization event overrun
pub fn ege(&mut self) -> _EGEW
[src]
Bit 9 - Event generation enable/disable
pub fn se(&mut self) -> _SEW
[src]
Bit 16 - Synchronous operating mode enable/disable
pub fn spol(&mut self) -> _SPOLW
[src]
Bits 17:18 - Synchronization event type selector Defines the synchronization event on the selected synchronization input:
pub fn nbreq(&mut self) -> _NBREQW
[src]
Bits 19:23 - Number of DMA requests to forward Defines the number of DMA requests forwarded before output event is generated. In synchronous mode, it also defines the number of DMA requests to forward after a synchronization event, then stop forwarding. The actual number of DMA requests forwarded is NBREQ+1. Note: This field can only be written when both SE and EGE bits are reset.
pub fn sync_id(&mut self) -> _SYNC_IDW
[src]
Bits 24:28 - Synchronization input selected
Auto Trait Implementations
Blanket Implementations
impl<T> From<T> for T
[src]
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same<T> for T
type Output = T
Should always be Self