Struct msp432p401r::sysctl::sys_nmi_ctlstat::R

pub struct R(_);

Register SYS_NMI_CTLSTAT reader

Implementations

impl R

pub fn cs_src(&self) -> CS_SRC_R

Bit 0 - CS interrupt as a source of NMI

pub fn pss_src(&self) -> PSS_SRC_R

Bit 1 - PSS interrupt as a source of NMI

pub fn pcm_src(&self) -> PCM_SRC_R

Bit 2 - PCM interrupt as a source of NMI

pub fn pin_src(&self) -> PIN_SRC_R

Bit 3 - RSTn/NMI pin configuration Note: When the device enters LPM3/LPM4 modes of operation, the functionality selected by this bit is retained. If selected as an NMI, activity on this pin in LPM3/LPM4 wakes the device and processes the interrupt, without causing a POR. If selected as a Reset, activity on this pin in LPM3/LPM4 causes a device-level POR When the device enters LPM3.5/LPM4.5 modes of operation, this bit is always cleared to 0. In other words, the RSTn/NMI pin always assumes a reset functionality in LPM3.5/LPM4.5 modes.

pub fn cs_flg(&self) -> CS_FLG_R

Bit 16 - CS interrupt was the source of NMI

pub fn pss_flg(&self) -> PSS_FLG_R

Bit 17 - PSS interrupt was the source of NMI

pub fn pcm_flg(&self) -> PCM_FLG_R

Bit 18 - PCM interrupt was the source of NMI

pub fn pin_flg(&self) -> PIN_FLG_R

Bit 19 - RSTn/NMI pin was the source of NMI

Methods from Deref<Target = R<SYS_NMI_CTLSTAT_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SYS_NMI_CTLSTAT_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<SYS_NMI_CTLSTAT_SPEC>> for R

fn from(reader: R<SYS_NMI_CTLSTAT_SPEC>) -> Self

Performs the conversion.