hm11 0.2.1

HM-11 Bluetooth AT driver crate
Documentation 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69

//! Test the serial interface
//!
//! This example requires you to short (connect) the TX and RX pins.
#![deny(unsafe_code)]
// #![deny(warnings)]
#![no_main]
#![no_std]

extern crate cortex_m;
extern crate cortex_m_rt as rt;
extern crate nb;
extern crate panic_semihosting;
extern crate hm11;

extern crate stm32l4xx_hal as hal;

use cortex_m::asm;
use crate::hal::prelude::*;
use crate::hal::serial::Serial;
use crate::hal::delay::Delay;
use crate::hal::stm32;
use hm11::Hm11;
use hm11::command::Command;
use crate::rt::entry;


#[entry]
fn main() -> ! {
    let p = stm32::Peripherals::take().unwrap();
    let cp = cortex_m::Peripherals::take().unwrap();

    let mut flash = p.FLASH.constrain();
    let mut rcc = p.RCC.constrain();
    let mut gpioa = p.GPIOA.split(&mut rcc.ahb2);

    let clocks = rcc.cfgr.freeze(&mut flash.acr);
    // TRY this alternate clock configuration (clocks run at nearly the maximum frequency)
    // let clocks = rcc.cfgr.sysclk(64.mhz()).pclk1(32.mhz()).freeze(&mut flash.acr);

    let mut delay = Delay::new(cp.SYST, clocks);

    let tx = gpioa.pa2.into_af7(&mut gpioa.moder, &mut gpioa.afrl);
    let rx = gpioa.pa3.into_af7(&mut gpioa.moder, &mut gpioa.afrl);
    
    let serial = Serial::usart2(p.USART2, (tx, rx), 115200.bps(), clocks, &mut rcc.apb1r1);

    let (tx, rx) = serial.split();

    let mut hm11 = Hm11::new(tx, rx);
    // check presence with AT
    hm11.send_with_delay(Command::Test, &mut delay).unwrap();
    // Set a mode
    hm11.send_with_delay(Command::SystemLedMode(true), &mut delay).unwrap();
    // reset the module
    hm11.send_with_delay(Command::Reset, &mut delay).unwrap();
    
    // let (usart2, (tx, rx)) = hm11.release().0.free(); // TODO the hal needs a way to recombine back to serial
    // let serial = Serial::usart2(usart2, (tx, rx), 115200.bps(), clocks, &mut rcc.apb1r1);
    // let (tx, rx) = serial.split();
    
    // let mut hm11 = Hm11::new(tx, rx);
    // // check presence with AT
    // hm11.command(Command::Test).unwrap();

    // if all goes well you should reach this breakpoint
    asm::bkpt();

    loop {}
}