e(s) found
ERROR: USB_MAX_HUB (%d) reached
usb_pgood_delay Can't allocate memory for USB device!
Port %d over-current occurred %d times
cannot reset port %i!?
cannot create new device: ret=%d Port not available.
lowlevel init failed
USB error: all controllers failed lowlevel init
scanning bus %d for devices... No USB Device found
%d USB Device(s) found
USB%d: EHCI fail to reset
USB EHCI %x.%02x
usb_new_device: Cannot read configuration, skipping device %04x:%04x
ERROR: NOT USB_CONFIG_DESC %x
ERROR: Invalid USB CFG length (%d)
ERROR: Invalid USB IF length (%d)
USB IF descriptor overflowed buffer!
Too many USB interfaces!
ERROR: Invalid USB EP length (%d)
USB EP descriptor overflowed buffer!
Endpoint descriptor out of order!
Interface %d has too many endpoints!
ERROR: Invalid USB EPC length (%d)
USB EPC descriptor overflowed buffer!
EPC descriptor out of order!
failed to set default configuration len %d, status %lX
selecting invalid interface %d %s: invalid max packet size
Cannot allocate device context to get SLOT_ID
USB device not accepting new address (error=%lX)
12 Mb/s +- %s (%s, %dmA)
%s %s %s %s
failed to stop USB controller %d
Did not get interrupt on CBI
cmd 0x%02X returned 0x%02X 0x%02X 0x%02X 0x%02X (NOT READY)
cmd 0x%02X returned 0x%02X 0x%02X 0x%02X 0x%02X
error in inquiry
Device NOT ready
Request Sense returned %02X %02X %02X
READ_CAP ERROR
No storage devices, perhaps not 'usb start'ed..?
scanning usb for storage devices... max USB Storage Device reached: %d stopping
%d Storage Device(s) found
USB Storage Transport unknown / not yet implemented
Sorry, protocol %d not yet supported.
ERROR: %s - start address is not aligned - 0x%08x
ERROR: %s - stop address is not aligned - 0x%08x
## No elf image at address 0x%08lx
## Not a 32-bit elf image at address 0x%08lx
U-Boot 2017.11+fslc+ga07698f (Sep 10 2018 - 21:06:01 +0000) Error: no valid bmp image at %lx
Error: compression type %ld not supported
4bpp bitmap unsupported with current