Struct esp32s2::io_mux::gpio27::R

pub struct R(_);

Register GPIO27 reader

Implementations

impl R

pub fn mcu_oe(&self) -> MCU_OE_R

Bit 0 - Output enable of the pin in sleep mode. 1: Output enabled. 0: Output disabled.

pub fn slp_sel(&self) -> SLP_SEL_R

Bit 1 - Sleep mode selection of this pin. Set to 1 to put the pin in sleep mode.

pub fn mcu_wpd(&self) -> MCU_WPD_R

Bit 2 - Pull-down enable of the pin during sleep mode. 1: Internal pull-down enabled. 0: internal pull-down disabled.

pub fn mcu_wpu(&self) -> MCU_WPU_R

Bit 3 - Pull-up enable of the pin during sleep mode. 1: Internal pull-up enabled. 0: Internal pull-up disabled.

pub fn mcu_ie(&self) -> MCU_IE_R

Bit 4 - Input enable of the pin during sleep mode. 1: Input enabled. 0: Input disabled.

pub fn fun_wpd(&self) -> FUN_WPD_R

Bit 7 - Pull-down enable of the pin. 1: Internal pull-down enabled. 0: internal pull-down disabled.

pub fn fun_wpu(&self) -> FUN_WPU_R

Bit 8 - Pull-up enable of the pin. 1: Internal pull-up enabled. 0: Internal pull-up disabled.

pub fn fun_ie(&self) -> FUN_IE_R

Bit 9 - Input enable of the pin. 1: Input enabled. 0: Input disabled.

pub fn fun_drv(&self) -> FUN_DRV_R

Bits 10:11 - Select the drive strength of the pin. 0: ~5 mA. 1: ~10 mA. 2: ~20 mA. 3: ~40 mA.

pub fn mcu_sel(&self) -> MCU_SEL_R

Bits 12:14 - Select IO MUX function for this signal. 0: Select Function 1. 1: Select Function 2, etc.

pub fn filter_en(&self) -> FILTER_EN_R

Bit 15 - Enable filter for pin input signals. 1: Filter enabled. 2: Filter disabled.

Methods from Deref<Target = R<GPIO27_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<GPIO27_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<GPIO27_SPEC>> for R

fn from(reader: R<GPIO27_SPEC>) -> Self

Converts to this type from the input type.