Struct esp32::sdmmc::hcon::R

pub struct R(_);

Register HCON reader

Implementations

impl R

pub fn card_type(&self) -> CARD_TYPE_R

Bit 0 - Hardware support SDIO and MMC.

pub fn card_num(&self) -> CARD_NUM_R

Bits 1:5 - Support card number is 2.

pub fn bus_type(&self) -> BUS_TYPE_R

Bit 6 - Register config is APB bus.

pub fn data_width(&self) -> DATA_WIDTH_R

Bits 7:9 - Regisger data widht is 32.

pub fn addr_width(&self) -> ADDR_WIDTH_R

Bits 10:15 - Register address width is 32.

pub fn dma_width(&self) -> DMA_WIDTH_R

Bits 18:20 - DMA data witdth is 32.

pub fn ram_indise(&self) -> RAM_INDISE_R

Bit 21 - Inside RAM in SDMMC module.

pub fn hold(&self) -> HOLD_R

Bit 22 - Have a hold regiser in data path .

pub fn num_clk_div(&self) -> NUM_CLK_DIV_R

Bits 24:25 - Have 4 clk divider in design .

Methods from Deref<Target = R<HCON_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<HCON_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<HCON_SPEC>> for R

fn from(reader: R<HCON_SPEC>) -> Self

Converts to this type from the input type.