esp-idf-hal 0.46.1

A Hardware abstraction layer for Espressif's ESP family of microcontrollers based on the ESP-IDF framework.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31

//! Turn an LED on/off depending on the state of a button
//!
//! This assumes that a LED is connected to GPIO4.
//! Additionally this assumes a button connected to GPIO9.
//! On an ESP32C3 development board this is the BOOT button.
//!
//! Depending on your target and the board you are using you should change the pins.
//! If your board doesn't have on-board LEDs don't forget to add an appropriate resistor.

use esp_idf_hal::delay::FreeRtos;
use esp_idf_hal::gpio::*;
use esp_idf_hal::peripherals::Peripherals;

fn main() -> anyhow::Result<()> {
    esp_idf_hal::sys::link_patches();

    let peripherals = Peripherals::take()?;
    let mut led = PinDriver::output(peripherals.pins.gpio4)?;
    let button = PinDriver::input(peripherals.pins.gpio9, Pull::Down)?;

    loop {
        // we are using thread::sleep here to make sure the watchdog isn't triggered
        FreeRtos::delay_ms(10);

        if button.is_high() {
            led.set_low()?;
        } else {
            led.set_high()?;
        }
    }
}