[−][src]Struct cc13x2_cc26x2_hal::prcm::i2sclkctl::R
Value read from the register
Methods
impl R
[src]
pub fn bits(&self) -> u32
[src]
Value of the register as raw bits
pub fn reserved4(&self) -> RESERVED4R
[src]
Bits 4:31 - 31:4] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn smpl_on_posedge(&self) -> SMPL_ON_POSEDGER
[src]
Bit 3 - 3:3] On the I2S serial interface, data and WCLK is sampled and clocked out on opposite edges of BCLK. 0 - data and WCLK are sampled on the negative edge and clocked out on the positive edge. 1 - data and WCLK are sampled on the positive edge and clocked out on the negative edge. For changes to take effect, CLKLOADCTL.LOAD needs to be written
pub fn wclk_phase(&self) -> WCLK_PHASER
[src]
Bits 1:2 - 2:1] Decides how the WCLK division ratio is calculated and used to generate different duty cycles (See I2SWCLKDIV.WDIV). 0: Single phase 1: Dual phase 2: User Defined 3: Reserved/Undefined For changes to take effect, CLKLOADCTL.LOAD needs to be written
pub fn en(&self) -> ENR
[src]
Bit 0 - 0:0] 0: MCLK, BCLK and WCLK will be static low 1: Enables the generation of MCLK, BCLK and WCLK For changes to take effect, CLKLOADCTL.LOAD needs to be written
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T> From for T
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self