arduino_mkr1000 0.4.0

Board Support crate for the Arduino MKR 1000 WiFi
Documentation 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36

# Arduino MKR WiFi 1000 Board Support Crate

This crate provides a type-safe API for working with the [Arduino MKR WiFi 1000 board](https://store.arduino.cc/arduino-mkr1000).

## Examples

### Blinky Basic

#### Requirements

 - Arduino IDE installed
    - samd package installed (You can do this by going to Tools->Board->BoardManager and then searching for `samd`
    - Now the arduino distribution contains bossac.exe in `ArduinoData/packages/arduino/tools/bossac/1.7.0[-arduino3]/` add it to your path
       - **linux**: `ArduinoData` is likely something like `~/.arduino15/`
       - **OSX**: `ArduinoData` is likely something like `~/Library/Arduino15`
    - Now the arduino distribution contains bossac.exe in `ArduinoData/packages/arduino/tools/bossac/1.7.0/` add it to your path
       - `ArduinoData` is likely something like `~/.arduino15/`
    - Probably best to install an example sketch via the IDE just to make sure everything is working
    - Note that the [arduino cli](https://github.com/arduino/arduino-cli) (or just regular bossac) may soon replace this section
 - arm-none-eabi tools installed, you need gcc and objcopy.
   -  **Note**: Alternatively, you can use [cargo-binutils](https://github.com/rust-embedded/cargo-binutils), which is likely easier to install on OSX and also easier to use, as it will automatically detect the target
 - thumbv6m-none-eabi rust target installed via `rustup target add thumbv6m-none-eabi`

#### Steps

Note: Before you run bossac, you need to double-press the center button to reset when re-flashing the device. 
This sets the device in a bootloader mode.

```bash
cargo build --release --example blinky_basic
arm-none-eabi-objcopy -O binary target/thumbv6m-none-eabi/release/examples/blinky_basic target/blinky_basic.bin
# if using cargo-binutils, you can `rust-objcopy` with the same flags, or combine the previous 2 steps with `cargo objcopy`
bossac -i -d -U true -i -e -w -v target/blinky_basic.bin -R
```

(You may need to use `--port` with something like `/dev/ttyACM0` or `/dev/ttyACM1`