[−][src]Crate arduino_mkr1000

Re-exports

pub use hal::target_device as pac;

calibration	NVM Software Calibration Area Mapping
clock	Configuring the system clock sources. You will typically need to create an instance of `GenericClockController` before you can set up most of the peripherals on the atsamd21 device. The other types in this module are used to enforce at compile time that the peripherals have been correctly configured.
delay	Delays
eic
gpio	GPIO
pad
prelude	Import the prelude to gain convenient access to helper traits
rtc	Real-time clock/counter
sercom	Configure the SERCOM peripherals
sleeping_delay	Delays with WFI sleep while we wait using a timer
spi_common
time	Time units
timer	Working with timer counter hardware
timer_params	helper struct to calculate divider & cycles settings for timers.
timer_traits

Pins	Maps the pins to their arduino names and the numbers printed on the board.

ResetCause represents the reason the MCU was reset.

reset_cause	Returns the cause of the last reset.
serial_number	Returns the serial number of the chip as an array of bytes. The serial number is only guaranteed to be unique if all 16 bytes are used.
split_serial_number	Returns the serial number of the chip as 4 32-bit integers. The serial number is only guaranteed to be unique if all 128 bits are used.
uart	Convenience for setting up the labelled RX, TX pins to operate as a UART device running at the specified baud.

Attribute to declare the entry point of the program