[−][src]Struct cc13x2_cc26x2_hal::gpio::dout7_4::R
Value read from the register
Methods
impl R
[src]
pub fn bits(&self) -> u32
[src]
Value of the register as raw bits
pub fn reserved25(&self) -> RESERVED25R
[src]
Bits 25:31 - 31:25] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio7(&self) -> DIO7R
[src]
Bit 24 - 24:24] Sets the state of the pin that is configured as DIO#7, if the corresponding DOE31_0 bitfield is set.
pub fn reserved17(&self) -> RESERVED17R
[src]
Bits 17:23 - 23:17] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio6(&self) -> DIO6R
[src]
Bit 16 - 16:16] Sets the state of the pin that is configured as DIO#6, if the corresponding DOE31_0 bitfield is set.
pub fn reserved9(&self) -> RESERVED9R
[src]
Bits 9:15 - 15:9] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio5(&self) -> DIO5R
[src]
Bit 8 - 8:8] Sets the state of the pin that is configured as DIO#5, if the corresponding DOE31_0 bitfield is set.
pub fn reserved1(&self) -> RESERVED1R
[src]
Bits 1:7 - 7:1] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio4(&self) -> DIO4R
[src]
Bit 0 - 0:0] Sets the state of the pin that is configured as DIO#4, if the corresponding DOE31_0 bitfield is set.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self