[−][src]Struct cc13x2_cc26x2_hal::crypto::dmach0ctl::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn reserved2(&mut self) -> _RESERVED2W
[src]
Bits 2:31 - 31:2] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn prio(&mut self) -> _PRIOW
[src]
Bit 1 - 1:1] Channel priority 0: Low 1: High If both channels have the same priority, access of the channels to the external port is arbitrated using the round robin scheme. If one channel has a high priority and another one low, the channel with the high priority is served first, in case of simultaneous access requests.
pub fn en(&mut self) -> _ENW
[src]
Bit 0 - 0:0] Channel enable 0: Disabled 1: Enable Note: Disabling an active channel interrupts the DMA operation. The ongoing block transfer completes, but no new transfers are requested.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self