[−][src]Struct cc13x2_cc26x2_hal::cpu_scs::hfsr::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn debugevt(&mut self) -> _DEBUGEVTW
[src]
Bit 31 - 31:31] This bit is set if there is a fault related to debug. This is only possible when halting debug is not enabled. For monitor enabled debug, it only happens for BKPT when the current priority is higher than the monitor. When both halting and monitor debug are disabled, it only happens for debug events that are not ignored (minimally, BKPT). The Debug Fault Status Register is updated.
pub fn forced(&mut self) -> _FORCEDW
[src]
Bit 30 - 30:30] Hard Fault activated because a Configurable Fault was received and cannot activate because of priority or because the Configurable Fault is disabled. The Hard Fault handler then has to read the other fault status registers to determine cause.
pub fn reserved2(&mut self) -> _RESERVED2W
[src]
Bits 2:29 - 29:2] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn vecttbl(&mut self) -> _VECTTBLW
[src]
Bit 1 - 1:1] This bit is set if there is a fault because of vector table read on exception processing (Bus Fault). This case is always a Hard Fault. The return PC points to the pre-empted instruction.
pub fn reserved0(&mut self) -> _RESERVED0W
[src]
Bit 0 - 0:0] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self