[−][src]Struct cc13x2_cc26x2_hal::aux_ddi0_osc::stat2::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn adc_dcbias(&mut self) -> _ADC_DCBIASW
[src]
Bits 26:31 - 31:26] DC Bias read by RADC during SAR mode The value is an unsigned integer. It is used for debug only.
pub fn hpm_ramp1_thmet(&mut self) -> _HPM_RAMP1_THMETW
[src]
Bit 25 - 25:25] Indication of threshold is met for hpm_ramp1
pub fn hpm_ramp2_thmet(&mut self) -> _HPM_RAMP2_THMETW
[src]
Bit 24 - 24:24] Indication of threshold is met for hpm_ramp2
pub fn hpm_ramp3_thmet(&mut self) -> _HPM_RAMP3_THMETW
[src]
Bit 23 - 23:23] Indication of threshold is met for hpm_ramp3
pub fn reserved16(&mut self) -> _RESERVED16W
[src]
Bits 16:22 - 22:16] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn rampstate(&mut self) -> _RAMPSTATEW
[src]
Bits 12:15 - 15:12] xosc_hf amplitude compensation FSM This is identical to STAT1.RAMPSTATE. See that description for encoding.
pub fn reserved4(&mut self) -> _RESERVED4W
[src]
Bits 4:11 - 11:4] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn ampcomp_req(&mut self) -> _AMPCOMP_REQW
[src]
Bit 3 - 3:3] ampcomp_req
pub fn xosc_hf_ampgood(&mut self) -> _XOSC_HF_AMPGOODW
[src]
Bit 2 - 2:2] amplitude of xosc_hf is within the required threshold (set by DDI). Not used for anything just for debug/status
pub fn xosc_hf_freqgood(&mut self) -> _XOSC_HF_FREQGOODW
[src]
Bit 1 - 1:1] frequency of xosc_hf is good to use for the digital clocks
pub fn xosc_hf_rf_freqgood(&mut self) -> _XOSC_HF_RF_FREQGOODW
[src]
Bit 0 - 0:0] frequency of xosc_hf is within +/- 20 ppm and xosc_hf is good for radio operations. Used for SW to start synthesizer.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self