[−][src]Struct cc13x2_cc26x2_hal::gpio::dout19_16::W
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn reserved25(&mut self) -> _RESERVED25W
[src]
Bits 25:31 - 31:25] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio19(&mut self) -> _DIO19W
[src]
Bit 24 - 24:24] Sets the state of the pin that is configured as DIO#19, if the corresponding DOE31_0 bitfield is set.
pub fn reserved17(&mut self) -> _RESERVED17W
[src]
Bits 17:23 - 23:17] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio18(&mut self) -> _DIO18W
[src]
Bit 16 - 16:16] Sets the state of the pin that is configured as DIO#18, if the corresponding DOE31_0 bitfield is set.
pub fn reserved9(&mut self) -> _RESERVED9W
[src]
Bits 9:15 - 15:9] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio17(&mut self) -> _DIO17W
[src]
Bit 8 - 8:8] Sets the state of the pin that is configured as DIO#17, if the corresponding DOE31_0 bitfield is set.
pub fn reserved1(&mut self) -> _RESERVED1W
[src]
Bits 1:7 - 7:1] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn dio16(&mut self) -> _DIO16W
[src]
Bit 0 - 0:0] Sets the state of the pin that is configured as DIO#16, if the corresponding DOE31_0 bitfield is set.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self