Struct cc13x2_cc26x2_hal::ssi1::cr1::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn sod(&mut self) -> _SODW

Bit 3 - 3:3] Slave-mode output disabled This bit is relevant only in the slave mode, MS=1. In multiple-slave systems, it is possible for an SSI master to broadcast a message to all slaves in the system while ensuring that only one slave drives data onto its serial output line. In such systems the RXD lines from multiple slaves could be tied together. To operate in such systems, this bitfield can be set if the SSI slave is not supposed to drive the TXD line: 0: SSI can drive the TXD output in slave mode. 1: SSI cannot drive the TXD output in slave mode.

pub fn ms(&mut self) -> _MSW

Bit 2 - 2:2] Master or slave mode select. This bit can be modified only when SSI is disabled, SSE=0.

pub fn sse(&mut self) -> _SSEW

Bit 1 - 1:1] Synchronous serial interface enable.

pub fn lbm(&mut self) -> _LBMW

Bit 0 - 0:0] Loop back mode: 0: Normal serial port operation enabled. 1: Output of transmit serial shifter is connected to input of receive serial shifter internally.