Struct cc13x2_cc26x2_hal::crypto::AESDATAIN1

pub struct AESDATAIN1 { /* fields omitted */ }

AES Data Input_Output 0 The data registers are typically accessed through the DMA and not with host writes and/or reads. However, for debugging purposes the data input/output registers can be accessed via host write and read operations. The registers are used to buffer the input/output data blocks to/from the EIP-120t. Note: The data input buffer (AES_DATA_IN_n) and data output buffer (AES_DATA_OUT_n) are mapped to the same address locations. Writes (both DMA and host) to these addresses load the Input Buffer while reads pull from the Output Buffer. Therefore, for write access, the data input buffer is written; for read access, the data output buffer is read. The data input buffer must be written before starting an operation. The data output buffer contains valid data on completion of an operation. Therefore, any 128-bit data block can be split over multiple 32-bit word transfers; these can be mixed with other host transfers over the external interface.

Methods

impl AESDATAIN1

pub fn modify<F>(&self, f: F) where
    F: FnOnce(&R, &'w mut W) -> &'w mut W, 

Modifies the contents of the register

pub fn read(&self) -> R

Reads the contents of the register

pub fn write<F>(&self, f: F) where
    F: FnOnce(&mut W) -> &mut W, 

Writes to the register

pub fn reset(&self)

Writes the reset value to the register