Enum aws_sdk_ec2instanceconnect::error::SendSSHPublicKeyErrorKind

#[non_exhaustive]
pub enum SendSSHPublicKeyErrorKind {
    AuthException(AuthException),
    Ec2InstanceNotFoundException(Ec2InstanceNotFoundException),
    Ec2InstanceStateInvalidException(Ec2InstanceStateInvalidException),
    InvalidArgsException(InvalidArgsException),
    ServiceException(ServiceException),
    ThrottlingException(ThrottlingException),
    Unhandled(Box<dyn Error + Send + Sync + 'static>),
}

Types of errors that can occur for the SendSSHPublicKey operation.

Variants (Non-exhaustive)

Non-exhaustive enums could have additional variants added in future. Therefore, when matching against variants of non-exhaustive enums, an extra wildcard arm must be added to account for any future variants.

AuthException(AuthException)

Either your AWS credentials are not valid or you do not have access to the EC2 instance.

Ec2InstanceNotFoundException(Ec2InstanceNotFoundException)

The specified instance was not found.

Ec2InstanceStateInvalidException(Ec2InstanceStateInvalidException)

Unable to connect because the instance is not in a valid state. Connecting to a stopped or terminated instance is not supported. If the instance is stopped, start your instance, and try to connect again.

InvalidArgsException(InvalidArgsException)

One of the parameters is not valid.

ServiceException(ServiceException)

The service encountered an error. Follow the instructions in the error message and try again.

ThrottlingException(ThrottlingException)

The requests were made too frequently and have been throttled. Wait a while and try again. To increase the limit on your request frequency, contact AWS Support.

Unhandled(Box<dyn Error + Send + Sync + 'static>)

An unexpected error, e.g. invalid JSON returned by the service or an unknown error code

Trait Implementations

impl Debug for SendSSHPublicKeyErrorKind

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.