Enum xmc4800::can_node0::ncr::Init

pub enum Init {
    Value1 = 0,
    Value2 = 1,
}

Node Initialization

Value on reset: 1

Variants

Value1 = 0

0: Resetting bit INIT enables the participation of the node in the CAN traffic. If the CAN node is in the bus-off state, the ongoing bus-off recovery (which does not depend on the INIT bit) is continued. With the end of the bus-off recovery sequence the CAN node is allowed to take part in the CAN traffic. If the CAN node is not in the bus-off state, a sequence of 11 consecutive recessive bits must be detected before the node is allowed to take part in the CAN traffic.

Value2 = 1

1: Setting this bit terminates the participation of this node in the CAN traffic. Any ongoing frame transfer is cancelled and the transmit line goes recessive. If the CAN node is in the bus-off state, then the running bus-off recovery sequence is continued. If the INIT bit is still set after the successful completion of the bus-off recovery sequence, i.e. after detecting 128 sequences of 11 consecutive recessive bits (11 1), then the CAN node leaves the bus-off state but remains inactive as long as INIT remains set.

Trait Implementations

impl Clone for Init

fn clone(&self) -> Init

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Init

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<Init> for bool

fn from(variant: Init) -> Self

Converts to this type from the input type.

impl PartialEq for Init

fn eq(&self, other: &Init) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for Init

impl Eq for Init

impl StructuralPartialEq for Init