[−][src]Enum xmc4200::usic0_ch0::sctr::TRM_A
Transmission Mode
Value on reset: 0
Variants
0: The shift control signal is considered as inactive and data frame transfers are not possible.
1: The shift control signal is considered active if it is at 1-level. This is the setting to be programmed to allow data transfers.
2: The shift control signal is considered active if it is at 0-level. It is recommended to avoid this setting and to use the inversion in the DX2 stage in case of a low-active signal.
3: The shift control signal is considered active without referring to the actual signal level. Data frame transfer is possible after each edge of the signal.
Trait Implementations
impl Clone for TRM_A
[src]
fn clone(&self) -> TRM_A
[src]
fn clone_from(&mut self, source: &Self)
1.0.0[src]
impl Copy for TRM_A
[src]
impl Debug for TRM_A
[src]
impl From<TRM_A> for u8
[src]
impl PartialEq<TRM_A> for TRM_A
[src]
impl StructuralPartialEq for TRM_A
[src]
Auto Trait Implementations
Blanket Implementations
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> From<T> for T
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Same<T> for T
type Output = T
Should always be Self
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,