Crate trinket_m0
Source pub use atsamd_hal as hal;pub use hal::pac;
- delay
- Delays
- gpio
- GPIO
- pad
- prelude
- Import the prelude to gain convenient access to helper traits
- rtc
- Real-time clock/counter
- sercom
- Configure the SERCOM peripherals
- sleeping_delay
- Delays with WFI sleep while we wait using a timer
- spi_commonDeprecated
- thumbv6m
- time
- Time units
- timer_params
- helper struct to calculate divider & cycles settings for timers.
- timer_traits
- Dotstar
- Dotstar pins
- I2C
- I2C pins
- Pins
- Maps the pins to their arduino names and
the numbers printed on the board.
- Sets
- Sets of pins split apart by category
- UART
- UART pins
- USB
- USB pins
- ResetCause
- ResetCause represents the reason the MCU was reset.
- i2c_master
- Convenience for setting up the D0 and D2 pins to operate as I²C
SDA/SDL (respectively) running at the specified baud.
- reset_cause
- Returns the cause of the last reset.
- serial_number
- Returns the serial number of the chip as an array of bytes. The serial
number is only guaranteed to be unique if all 16 bytes are used.
- spi_master
- Convenience function for setting up the A7/D3/SCK, A6/D4/MOSI, and
A9/D2/MISO pins as a SPI Master.
- split_serial_number
- Returns the serial number of the chip as 4 32-bit integers. The serial
number is only guaranteed to be unique if all 128 bits are used.
- uart
- Convenience for setting up the D3 and D4 pins to
operate as UART RX/TX (respectively) running at the specified baud.
- entry