Struct stm32l5::stm32l562::sdmmc1::sdmmc_power::W

pub struct W(_);

Register SDMMC_POWER writer

Implementations

impl W

pub fn pwrctrl(&mut self) -> PWRCTRL_W<'_, 0>

Bits 0:1 - SDMMC state control bits. These bits can only be written when the SDMMC is not in the power-on state (PWRCTRL?11). These bits are used to define the functional state of the SDMMC signals: Any further write will be ignored, PWRCTRL value will keep 11.

pub fn vswitch(&mut self) -> VSWITCH_W<'_, 2>

Bit 2 - Voltage switch sequence start. This bit is used to start the timing critical section of the voltage switch sequence:

pub fn vswitchen(&mut self) -> VSWITCHEN_W<'_, 3>

Bit 3 - Voltage switch procedure enable. This bit can only be written by firmware when CPSM is disabled (CPSMEN = 0). This bit is used to stop the SDMMC_CK after the voltage switch command response:

pub fn dirpol(&mut self) -> DIRPOL_W<'_, 4>

Bit 4 - Data and command direction signals polarity selection. This bit can only be written when the SDMMC is in the power-off state (PWRCTRL = 00).

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<SDMMC_POWER_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<SDMMC_POWER_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<SDMMC_POWER_SPEC>> for W

fn from(writer: W<SDMMC_POWER_SPEC>) -> Self

Converts to this type from the input type.