[−][src]Struct stm32l4xx_hal::stm32::opamp::opamp2_csr::R
Value read from the register
Methods
impl R
[src]
pub fn bits(&self) -> u32
[src]
Value of the register as raw bits
pub fn opaen(&self) -> OPAENR
[src]
Bit 0 - Operational amplifier Enable
pub fn opalpm(&self) -> OPALPMR
[src]
Bit 1 - Operational amplifier Low Power Mode
pub fn opamode(&self) -> OPAMODER
[src]
Bits 2:3 - Operational amplifier PGA mode
pub fn pga_gain(&self) -> PGA_GAINR
[src]
Bits 4:5 - Operational amplifier Programmable amplifier gain value
pub fn vm_sel(&self) -> VM_SELR
[src]
Bits 8:9 - Inverting input selection
pub fn vp_sel(&self) -> VP_SELR
[src]
Bit 10 - Non inverted input selection
pub fn calon(&self) -> CALONR
[src]
Bit 12 - Calibration mode enabled
pub fn calsel(&self) -> CALSELR
[src]
Bit 13 - Calibration selection
pub fn usertrim(&self) -> USERTRIMR
[src]
Bit 14 - allows to switch from AOP offset trimmed values to AOP offset
pub fn calout(&self) -> CALOUTR
[src]
Bit 15 - Operational amplifier calibration output
Auto Trait Implementations
Blanket Implementations
impl<T> From for T
[src]
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = !
🔬 This is a nightly-only experimental API. (
try_from
)The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
🔬 This is a nightly-only experimental API. (
try_from
)The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self