Struct stm32h743::pwr::PWR_CR3
[−]
[src]
pub struct PWR_CR3 { /* fields omitted */ }
Reset only by POR only, not reset by wakeup from Standby mode and RESET pad. The lower byte of this register is written once after POR and shall be written before changing VOS level or ck_sys clock frequency. No limitation applies to the upper bytes.Programming data corresponding to an invalid combination of SDLEVEL, SDEXTHP, SDEN, LDOEN and BYPASS bits (see Table9) will be ignored: data will not be written, the written-once mechanism will lock the register and any further write access will be ignored. The default supply configuration will be kept and the ACTVOSRDY bit in PWR control status register 1 (PWR_CSR1) will go on indicating invalid voltage levels. The system shall be power cycled before writing a new value.
Methods
impl PWR_CR3
[src]
pub fn modify<F>(&self, f: F) where
F: FnOnce(&R, &'w mut W) -> &'w mut W,
[src]
F: FnOnce(&R, &'w mut W) -> &'w mut W,
Modifies the contents of the register
pub fn read(&self) -> R
[src]
Reads the contents of the register
pub fn write<F>(&self, f: F) where
F: FnOnce(&mut W) -> &mut W,
[src]
F: FnOnce(&mut W) -> &mut W,
Writes to the register
pub fn reset(&self)
[src]
Writes the reset value to the register