Struct stm32h7::stm32h747cm7::rtc::tampcr::W

pub struct W(_);

Register TAMPCR writer

Implementations

impl W

pub fn tamp1e(&mut self) -> TAMP1E_W<'_, 0>

Bit 0 - RTC_TAMP1 input detection enable

pub fn tamp1trg(&mut self) -> TAMP1TRG_W<'_, 1>

Bit 1 - Active level for RTC_TAMP1 input If TAMPFLT != 00 if TAMPFLT = 00:

pub fn tampie(&mut self) -> TAMPIE_W<'_, 2>

Bit 2 - Tamper interrupt enable

pub fn tamp2e(&mut self) -> TAMP2E_W<'_, 3>

Bit 3 - RTC_TAMP2 input detection enable

pub fn tamp2trg(&mut self) -> TAMP2TRG_W<'_, 4>

Bit 4 - Active level for RTC_TAMP2 input if TAMPFLT != 00: if TAMPFLT = 00:

pub fn tamp3e(&mut self) -> TAMP3E_W<'_, 5>

Bit 5 - RTC_TAMP3 detection enable

pub fn tamp3trg(&mut self) -> TAMP3TRG_W<'_, 6>

Bit 6 - Active level for RTC_TAMP3 input if TAMPFLT != 00: if TAMPFLT = 00:

pub fn tampts(&mut self) -> TAMPTS_W<'_, 7>

Bit 7 - Activate timestamp on tamper detection event TAMPTS is valid even if TSE=0 in the RTC_CR register.

pub fn tampfreq(&mut self) -> TAMPFREQ_W<'_, 8>

Bits 8:10 - Tamper sampling frequency Determines the frequency at which each of the RTC_TAMPx inputs are sampled.

pub fn tampflt(&mut self) -> TAMPFLT_W<'_, 11>

Bits 11:12 - RTC_TAMPx filter count These bits determines the number of consecutive samples at the specified level (TAMP*TRG) needed to activate a Tamper event. TAMPFLT is valid for each of the RTC_TAMPx inputs.

pub fn tampprch(&mut self) -> TAMPPRCH_W<'_, 13>

Bits 13:14 - RTC_TAMPx precharge duration These bit determines the duration of time during which the pull-up/is activated before each sample. TAMPPRCH is valid for each of the RTC_TAMPx inputs.

pub fn tamppudis(&mut self) -> TAMPPUDIS_W<'_, 15>

Bit 15 - RTC_TAMPx pull-up disable This bit determines if each of the RTC_TAMPx pins are pre-charged before each sample.

pub fn tamp1ie(&mut self) -> TAMP1IE_W<'_, 16>

Bit 16 - Tamper 1 interrupt enable

pub fn tamp1noerase(&mut self) -> TAMP1NOERASE_W<'_, 17>

Bit 17 - Tamper 1 no erase

pub fn tamp1mf(&mut self) -> TAMP1MF_W<'_, 18>

Bit 18 - Tamper 1 mask flag

pub fn tamp2ie(&mut self) -> TAMP2IE_W<'_, 19>

Bit 19 - Tamper 2 interrupt enable

pub fn tamp2noerase(&mut self) -> TAMP2NOERASE_W<'_, 20>

Bit 20 - Tamper 2 no erase

pub fn tamp2mf(&mut self) -> TAMP2MF_W<'_, 21>

Bit 21 - Tamper 2 mask flag

pub fn tamp3ie(&mut self) -> TAMP3IE_W<'_, 22>

Bit 22 - Tamper 3 interrupt enable

pub fn tamp3noerase(&mut self) -> TAMP3NOERASE_W<'_, 23>

Bit 23 - Tamper 3 no erase

pub fn tamp3mf(&mut self) -> TAMP3MF_W<'_, 24>

Bit 24 - Tamper 3 mask flag

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<TAMPCR_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<TAMPCR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<TAMPCR_SPEC>> for W

fn from(writer: W<TAMPCR_SPEC>) -> Self

Converts to this type from the input type.