Struct stm32h7::stm32h743v::i2c1::timeoutr::W

pub struct W(_);

Register TIMEOUTR writer

Implementations

impl W

pub fn timeouta(&mut self) -> TIMEOUTA_W<'_, 0>

Bits 0:11 - Bus Timeout A This field is used to configure: The SCL low timeout condition tTIMEOUT when TIDLE=0 tTIMEOUT= (TIMEOUTA+1) x 2048 x tI2CCLK The bus idle condition (both SCL and SDA high) when TIDLE=1 tIDLE= (TIMEOUTA+1) x 4 x tI2CCLK Note: These bits can be written only when TIMOUTEN=0.

pub fn tidle(&mut self) -> TIDLE_W<'_, 12>

Bit 12 - Idle clock timeout detection Note: This bit can be written only when TIMOUTEN=0.

pub fn timouten(&mut self) -> TIMOUTEN_W<'_, 15>

Bit 15 - Clock timeout enable

pub fn timeoutb(&mut self) -> TIMEOUTB_W<'_, 16>

Bits 16:27 - Bus timeout B This field is used to configure the cumulative clock extension timeout: In master mode, the master cumulative clock low extend time (tLOW:MEXT) is detected In slave mode, the slave cumulative clock low extend time (tLOW:SEXT) is detected tLOW:EXT= (TIMEOUTB+1) x 2048 x tI2CCLK Note: These bits can be written only when TEXTEN=0.

pub fn texten(&mut self) -> TEXTEN_W<'_, 31>

Bit 31 - Extended clock timeout enable

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<TIMEOUTR_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<TIMEOUTR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<TIMEOUTR_SPEC>> for W

fn from(writer: W<TIMEOUTR_SPEC>) -> Self

Converts to this type from the input type.