Struct stm32h7::stm32h743v::i2c1::timeoutr::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn timeouta(&mut self) -> _TIMEOUTAW

Bits 0:11 - Bus Timeout A This field is used to configure: The SCL low timeout condition tTIMEOUT when TIDLE=0 tTIMEOUT= (TIMEOUTA+1) x 2048 x tI2CCLK The bus idle condition (both SCL and SDA high) when TIDLE=1 tIDLE= (TIMEOUTA+1) x 4 x tI2CCLK Note: These bits can be written only when TIMOUTEN=0.

pub fn tidle(&mut self) -> _TIDLEW

Bit 12 - Idle clock timeout detection Note: This bit can be written only when TIMOUTEN=0.

pub fn timouten(&mut self) -> _TIMOUTENW

Bit 15 - Clock timeout enable

pub fn timeoutb(&mut self) -> _TIMEOUTBW

Bits 16:27 - Bus timeout B This field is used to configure the cumulative clock extension timeout: In master mode, the master cumulative clock low extend time (tLOW:MEXT) is detected In slave mode, the slave cumulative clock low extend time (tLOW:SEXT) is detected tLOW:EXT= (TIMEOUTB+1) x 2048 x tI2CCLK Note: These bits can be written only when TEXTEN=0.

pub fn texten(&mut self) -> _TEXTENW

Bit 31 - Extended clock timeout enable