Struct stm32h7::stm32h743::sai4::afrcr::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn frl(&mut self) -> _FRLW

Bits 0:7 - Frame length. These bits are set and cleared by software. They define the audio frame length expressed in number of SCK clock cycles: the number of bits in the frame is equal to FRL[7:0] + 1. The minimum number of bits to transfer in an audio frame must be equal to 8, otherwise the audio block will behaves in an unexpected way. This is the case when the data size is 8 bits and only one slot 0 is defined in NBSLOT[4:0] of SAI_xSLOTR register (NBSLOT[3:0] = 0000). In master mode, if the master clock (available on MCLK_x pin) is used, the frame length should be aligned with a number equal to a power of 2, ranging from 8 to 256. When the master clock is not used (NODIV = 1), it is recommended to program the frame length to an value ranging from 8 to 256. These bits are meaningless and are not used in AC97 or SPDIF audio block configuration.

pub fn fsall(&mut self) -> _FSALLW

Bits 8:14 - Frame synchronization active level length. These bits are set and cleared by software. They specify the length in number of bit clock (SCK) + 1 (FSALL[6:0] + 1) of the active level of the FS signal in the audio frame These bits are meaningless and are not used in AC97 or SPDIF audio block configuration. They must be configured when the audio block is disabled.

pub fn fspol(&mut self) -> _FSPOLW

Bit 17 - Frame synchronization polarity. This bit is set and cleared by software. It is used to configure the level of the start of frame on the FS signal. It is meaningless and is not used in AC97 or SPDIF audio block configuration. This bit must be configured when the audio block is disabled.

pub fn fsoff(&mut self) -> _FSOFFW

Bit 18 - Frame synchronization offset. This bit is set and cleared by software. It is meaningless and is not used in AC97 or SPDIF audio block configuration. This bit must be configured when the audio block is disabled.