[−][src]Struct stm32h7::stm32h743v::rtc::calr::R

pub struct R { /* fields omitted */ }

Value read from the register

Methods

impl R[src]

pub fn bits(&self) -> u32[src]

Value of the register as raw bits

pub fn calm(&self) -> CALMR[src]

Bits 0:8 - Calibration minus The frequency of the calendar is reduced by masking CALM out of 220 RTCCLK pulses (32 seconds if the input frequency is 32768 Hz). This decreases the frequency of the calendar with a resolution of 0.9537 ppm. To increase the frequency of the calendar, this feature should be used in conjunction with CALP. See Section24.3.12: RTC smooth digital calibration on page13.

pub fn calw16(&self) -> CALW16R[src]

Bit 13 - Use a 16-second calibration cycle period When CALW16 is set to 1, the 16-second calibration cycle period is selected.This bit must not be set to 1 if CALW8=1. Note: CALM[0] is stuck at 0 when CALW16= 1. Refer to Section24.3.12: RTC smooth digital calibration.

pub fn calw8(&self) -> CALW8R[src]

Bit 14 - Use an 8-second calibration cycle period When CALW8 is set to 1, the 8-second calibration cycle period is selected. Note: CALM[1:0] are stuck at 00; when CALW8= 1. Refer to Section24.3.12: RTC smooth digital calibration.

pub fn calp(&self) -> CALPR[src]

Bit 15 - Increase frequency of RTC by 488.5 ppm This feature is intended to be used in conjunction with CALM, which lowers the frequency of the calendar with a fine resolution. if the input frequency is 32768 Hz, the number of RTCCLK pulses added during a 32-second window is calculated as follows: (512 * CALP) - CALM. Refer to Section24.3.12: RTC smooth digital calibration.

Auto Trait Implementations

impl Unpin for R

impl Send for R

impl Sync for R

Blanket Implementations

impl<T, U> TryFrom<U> for T where
    U: Into<T>, [src]

type Error = Infallible

The type returned in the event of a conversion error.

impl<T, U> Into<U> for T where
    U: From<T>, [src]

impl<T> From<T> for T[src]

impl<T, U> TryInto<U> for T where
    U: TryFrom<T>, [src]

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.

impl<T> Borrow<T> for T where
    T: ?Sized, [src]

impl<T> BorrowMut<T> for T where
    T: ?Sized, [src]

impl<T> Any for T where
    T: 'static + ?Sized, [src]

impl<T> Same<T> for T

type Output = T

Should always be Self