[−][src]Struct stm32h7::stm32h743::mdma::c4cr::W
Value to write to the register
Methods
impl W
[src]
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn en(&mut self) -> _ENW
[src]
Bit 0 - channel enable
pub fn teie(&mut self) -> _TEIEW
[src]
Bit 1 - Transfer error interrupt enable This bit is set and cleared by software.
pub fn ctcie(&mut self) -> _CTCIEW
[src]
Bit 2 - Channel Transfer Complete interrupt enable This bit is set and cleared by software.
pub fn brtie(&mut self) -> _BRTIEW
[src]
Bit 3 - Block Repeat transfer interrupt enable This bit is set and cleared by software.
pub fn btie(&mut self) -> _BTIEW
[src]
Bit 4 - Block Transfer interrupt enable This bit is set and cleared by software.
pub fn tcie(&mut self) -> _TCIEW
[src]
Bit 5 - buffer Transfer Complete interrupt enable This bit is set and cleared by software.
pub fn pl(&mut self) -> _PLW
[src]
Bits 6:7 - Priority level These bits are set and cleared by software. These bits are protected and can be written only if EN is 0.
pub fn bex(&mut self) -> _BEXW
[src]
Bit 12 - byte Endianness exchange
pub fn hex(&mut self) -> _HEXW
[src]
Bit 13 - Half word Endianes exchange
pub fn wex(&mut self) -> _WEXW
[src]
Bit 14 - Word Endianness exchange
pub fn swrq(&mut self) -> _SWRQW
[src]
Bit 16 - SW ReQuest Writing a 1 into this bit sets the CRQAx in MDMA_ISRy register, activating the request on Channel x Note: Either the whole CxCR register or the 8-bit/16-bit register @ Address offset: 0x4E + 0x40 chn may be used for SWRQ activation. In case of a SW request, acknowledge is not generated (neither HW signal, nor CxMAR write access).
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> From<T> for T
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same<T> for T
type Output = T
Should always be Self