Struct stm32h7::stm32h743::fmc::pmem::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn memset(&mut self) -> _MEMSETW

Bits 0:7 - Common memory x setup time These bits define the number of KCK_FMC (+1) clock cycles to set up the address before the command assertion (NWE, NOE), for NAND Flash read or write access to common memory space:

pub fn memwait(&mut self) -> _MEMWAITW

Bits 8:15 - Common memory wait time These bits define the minimum number of KCK_FMC (+1) clock cycles to assert the command (NWE, NOE), for NAND Flash read or write access to common memory space. The duration of command assertion is extended if the wait signal (NWAIT) is active (low) at the end of the programmed value of KCK_FMC:

pub fn memhold(&mut self) -> _MEMHOLDW

Bits 16:23 - Common memory hold time These bits define the number of KCK_FMC clock cycles for write accesses and KCK_FMC+1 clock cycles for read accesses during which the address is held (and data for write accesses) after the command is de-asserted (NWE, NOE), for NAND Flash read or write access to common memory space:

pub fn memhiz(&mut self) -> _MEMHIZW

Bits 24:31 - Common memory x data bus Hi-Z time These bits define the number of KCK_FMC clock cycles during which the data bus is kept Hi-Z after the start of a NAND Flash write access to common memory space. This is only valid for write transactions: