[−][src]Struct stm32h7::stm32h743::flash::optsr_cur::W
Value to write to the register
Methods
impl W
[src]
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn opt_busy(&mut self) -> _OPT_BUSYW
[src]
Bit 0 - Option byte change ongoing flag
pub fn bor_lev(&mut self) -> _BOR_LEVW
[src]
Bits 2:3 - Brownout level option status bit
pub fn iwdg1_hw(&mut self) -> _IWDG1_HWW
[src]
Bit 4 - IWDG1 control option status bit
pub fn n_rst_stop_d1(&mut self) -> _NRST_STOP_D1W
[src]
Bit 6 - D1 DStop entry reset option status bit
pub fn n_rst_stby_d1(&mut self) -> _NRST_STBY_D1W
[src]
Bit 7 - D1 DStandby entry reset option status bit
pub fn rdp(&mut self) -> _RDPW
[src]
Bits 8:15 - Readout protection level option status byte
pub fn fz_iwdg_stop(&mut self) -> _FZ_IWDG_STOPW
[src]
Bit 17 - IWDG Stop mode freeze option status bit
pub fn fz_iwdg_sdby(&mut self) -> _FZ_IWDG_SDBYW
[src]
Bit 18 - IWDG Standby mode freeze option status bit
pub fn st_ram_size(&mut self) -> _ST_RAM_SIZEW
[src]
Bits 19:20 - DTCM RAM size option status
pub fn security(&mut self) -> _SECURITYW
[src]
Bit 21 - Security enable option status bit
pub fn rss1(&mut self) -> _RSS1W
[src]
Bit 26 - User option bit 1
pub fn perso_ok(&mut self) -> _PERSO_OKW
[src]
Bit 28 - Device personalization status bit
pub fn io_hslv(&mut self) -> _IO_HSLVW
[src]
Bit 29 - I/O high-speed at low-voltage status bit (PRODUCT_BELOW_25V)
pub fn optchangeerr(&mut self) -> _OPTCHANGEERRW
[src]
Bit 30 - Option byte change error flag
pub fn swap_bank_opt(&mut self) -> _SWAP_BANK_OPTW
[src]
Bit 31 - Bank swapping option status bit
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> From<T> for T
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same<T> for T
type Output = T
Should always be Self