[−][src]Struct stm32h7::stm32h743::dma2d::cr::W
Value to write to the register
Methods
impl W
[src]
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn start(&mut self) -> _STARTW
[src]
Bit 0 - Start This bit can be used to launch the DMA2D according to the parameters loaded in the various configuration registers
pub fn susp(&mut self) -> _SUSPW
[src]
Bit 1 - Suspend This bit can be used to suspend the current transfer. This bit is set and reset by software. It is automatically reset by hardware when the START bit is reset.
pub fn abort(&mut self) -> _ABORTW
[src]
Bit 2 - Abort This bit can be used to abort the current transfer. This bit is set by software and is automatically reset by hardware when the START bit is reset.
pub fn teie(&mut self) -> _TEIEW
[src]
Bit 8 - Transfer error interrupt enable This bit is set and cleared by software.
pub fn tcie(&mut self) -> _TCIEW
[src]
Bit 9 - Transfer complete interrupt enable This bit is set and cleared by software.
pub fn twie(&mut self) -> _TWIEW
[src]
Bit 10 - Transfer watermark interrupt enable This bit is set and cleared by software.
pub fn caeie(&mut self) -> _CAEIEW
[src]
Bit 11 - CLUT access error interrupt enable This bit is set and cleared by software.
pub fn ctcie(&mut self) -> _CTCIEW
[src]
Bit 12 - CLUT transfer complete interrupt enable This bit is set and cleared by software.
pub fn ceie(&mut self) -> _CEIEW
[src]
Bit 13 - Configuration Error Interrupt Enable This bit is set and cleared by software.
pub fn mode(&mut self) -> _MODEW
[src]
Bits 16:17 - DMA2D mode This bit is set and cleared by software. It cannot be modified while a transfer is ongoing.
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> From<T> for T
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same<T> for T
type Output = T
Should always be Self