Struct stm32g4::stm32g474::dac1::dac_mcr::W

pub struct W(_);

Register DAC_MCR writer

Implementations

impl W

pub fn mode1(&mut self) -> MODE1_W<'_, 0>

Bits 0:2 - DAC Channel 1 mode These bits can be written only when the DAC is disabled and not in the calibration mode (when bit EN1=0 and bit CEN1 =0 in the DAC_CR register). If EN1=1 or CEN1 =1 the write operation is ignored. They can be set and cleared by software to select the DAC Channel 1 mode: DAC Channel 1 in normal Mode DAC Channel 1 in sample & hold mode

pub fn dmadouble1(&mut self) -> DMADOUBLE1_W<'_, 8>

Bit 8 - DAC Channel1 DMA double data mode

pub fn sinformat1(&mut self) -> SINFORMAT1_W<'_, 9>

Bit 9 - Enable signed format for DAC channel1

pub fn hfsel(&mut self) -> HFSEL_W<'_, 14>

Bits 14:15 - High frequency interface mode selection

pub fn mode2(&mut self) -> MODE2_W<'_, 16>

Bits 16:18 - DAC Channel 2 mode These bits can be written only when the DAC is disabled and not in the calibration mode (when bit EN2=0 and bit CEN2 =0 in the DAC_CR register). If EN2=1 or CEN2 =1 the write operation is ignored. They can be set and cleared by software to select the DAC Channel 2 mode: DAC Channel 2 in normal Mode DAC Channel 2 in sample & hold mode

pub fn dmadouble2(&mut self) -> DMADOUBLE2_W<'_, 24>

Bit 24 - DAC Channel2 DMA double data mode

pub fn sinformat2(&mut self) -> SINFORMAT2_W<'_, 25>

Bit 25 - Enable signed format for DAC channel2

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<DAC_MCR_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<DAC_MCR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<DAC_MCR_SPEC>> for W

fn from(writer: W<DAC_MCR_SPEC>) -> Self

Converts to this type from the input type.