Struct stm32g0::stm32g0c1::tim14::ccmr1_output::R

pub struct R(_);

Register CCMR1_Output reader

Implementations

impl R

pub fn cc1s(&self) -> CC1S_R

Bits 0:1 - Capture/Compare 1 selection This bit-field defines the direction of the channel (input/output) as well as the used input. Note: CC1S bits are writable only when the channel is OFF (CC1E = 0 in TIMx_CCER).

pub fn oc1fe(&self) -> OC1FE_R

Bit 2 - Output compare 1 fast enable This bit decreases the latency between a trigger event and a transition on the timer output. It must be used in one-pulse mode (OPM bit set in TIMx_CR1 register), to have the output pulse starting as soon as possible after the starting trigger.

pub fn oc1pe(&self) -> OC1PE_R

Bit 3 - Output compare 1 preload enable Note: The PWM mode can be used without validating the preload register only in one pulse mode (OPM bit set in TIMx_CR1 register). Else the behavior is not guaranteed.

pub fn oc1m(&self) -> OC1M_R

Bits 4:6 - Output compare 1 mode (refer to bit 16 for OC1M[3]) These bits define the behavior of the output reference signal OC1REF from which OC1 is derived. OC1REF is active high whereas OC1 active level depends on CC1P bit. Others: Reserved Note: In PWM mode 1 or 2, the OCREF level changes when the result of the comparison changes or when the output compare mode switches from frozen to PWM mode. Note: The OC1M[3] bit is not contiguous, located in bit 16.

pub fn oc1m_3(&self) -> OC1M_3_R

Bit 16 - Output compare 1 mode (refer to bit 16 for OC1M[3]) These bits define the behavior of the output reference signal OC1REF from which OC1 is derived. OC1REF is active high whereas OC1 active level depends on CC1P bit. Others: Reserved Note: In PWM mode 1 or 2, the OCREF level changes when the result of the comparison changes or when the output compare mode switches from frozen to PWM mode. Note: The OC1M[3] bit is not contiguous, located in bit 16.

Methods from Deref<Target = R<CCMR1_OUTPUT_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CCMR1_OUTPUT_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CCMR1_OUTPUT_SPEC>> for R

fn from(reader: R<CCMR1_OUTPUT_SPEC>) -> Self

Converts to this type from the input type.