Module stm32g0::stm32g0c1::rtc::calr

source · [−]
Expand description

RTC calibration register

Structs

CALR_SPEC

RTC calibration register

R

Register CALR reader

W

Register CALR writer

Type Definitions

CALM_R

Field CALM reader - Calibration minus The frequency of the calendar is reduced by masking CALM out of 220 RTCCLK pulses (32 seconds if the input frequency is 32768Â Hz). This decreases the frequency of the calendar with a resolution of 0.9537Â ppm. To increase the frequency of the calendar, this feature should be used in conjunction with CALP. See .

CALM_W

Field CALM writer - Calibration minus The frequency of the calendar is reduced by masking CALM out of 220 RTCCLK pulses (32 seconds if the input frequency is 32768Â Hz). This decreases the frequency of the calendar with a resolution of 0.9537Â ppm. To increase the frequency of the calendar, this feature should be used in conjunction with CALP. See .

CALP_R

Field CALP reader - Increase frequency of RTC by 488.5 ppm This feature is intended to be used in conjunction with CALM, which lowers the frequency of the calendar with a fine resolution. if the input frequency is 32768 Hz, the number of RTCCLK pulses added during a 32-second window is calculated as follows: (512 × CALP) - CALM. Refer to .

CALP_W

Field CALP writer - Increase frequency of RTC by 488.5 ppm This feature is intended to be used in conjunction with CALM, which lowers the frequency of the calendar with a fine resolution. if the input frequency is 32768 Hz, the number of RTCCLK pulses added during a 32-second window is calculated as follows: (512 × CALP) - CALM. Refer to .

CALW8_R

Field CALW8 reader - Use an 8-second calibration cycle period When CALW8 is set to 1, the 8-second calibration cycle period is selected. Note: CALM[1:0] are stuck at 00 when CALW8 = 1. Refer to digital calibration.

CALW8_W

Field CALW8 writer - Use an 8-second calibration cycle period When CALW8 is set to 1, the 8-second calibration cycle period is selected. Note: CALM[1:0] are stuck at 00 when CALW8 = 1. Refer to digital calibration.

CALW16_R

Field CALW16 reader - Use a 16-second calibration cycle period When CALW16 is set to 1, the 16-second calibration cycle period is selected. This bit must not be set to 1 if CALW8 = 1. Note: CALM[0] is stuck at 0 when CALW16 = 1. Refer to calibration.

CALW16_W

Field CALW16 writer - Use a 16-second calibration cycle period When CALW16 is set to 1, the 16-second calibration cycle period is selected. This bit must not be set to 1 if CALW8 = 1. Note: CALM[0] is stuck at 0 when CALW16 = 1. Refer to calibration.