Enum stm32g0::stm32g0c1::adc::cr::ADSTART_AW

pub enum ADSTART_AW {
    StartConversion,
}

ADC start conversion command This bit is set by software to start ADC conversion. Depending on the EXTEN [1:0] configuration bits, a conversion either starts immediately (software trigger configuration) or once a hardware trigger event occurs (hardware trigger configuration). It is cleared by hardware: In single conversion mode (CONTÂ =Â 0, DISCENÂ =Â 0), when software trigger is selected (EXTENÂ =Â 00): at the assertion of the end of Conversion Sequence (EOS) flag. In discontinuous conversion mode(CONTÂ =Â 0, DISCENÂ =Â 1), when the software trigger is selected (EXTENÂ =Â 00): at the assertion of the end of Conversion (EOC) flag. In all other cases: after the execution of the ADSTP command, at the same time as the ADSTP bit is cleared by hardware. Note: The software is allowed to set ADSTART only when ADENÂ =Â 1 and ADDISÂ =Â 0 (ADC is enabled and there is no pending request to disable the ADC). After writing to ADC_CHSELR register or changing CHSELRMOD or SCANDIRW, it is mandatory to wait until CCRDY flag is asserted before setting ADSTART, otherwise, the value written to ADSTART is ignored.

Value on reset: 0

Variants

StartConversion

1: Start the ADC conversion (may be delayed for hardware triggers)

Trait Implementations

impl Clone for ADSTART_AW

fn clone(&self) -> ADSTART_AW

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ADSTART_AW

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<ADSTART_AW> for bool

fn from(variant: ADSTART_AW) -> Self

Converts to this type from the input type.

impl PartialEq<ADSTART_AW> for ADSTART_AW

fn eq(&self, other: &ADSTART_AW) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=.

impl Copy for ADSTART_AW

impl StructuralPartialEq for ADSTART_AW