Struct stm32g0::stm32g0b0::tim1::cr1::R

pub struct R(_);

Register CR1 reader

Implementations

impl R

pub fn cen(&self) -> CEN_R

Bit 0 - Counter enable Note: External clock, gated mode and encoder mode can work only if the CEN bit has been previously set by software. However trigger mode can set the CEN bit automatically by hardware.

pub fn udis(&self) -> UDIS_R

Bit 1 - Update disable This bit is set and cleared by software to enable/disable UEV event generation. Counter overflow/underflow Setting the UG bit Update generation through the slave mode controller Buffered registers are then loaded with their preload values.

pub fn urs(&self) -> URS_R

Bit 2 - Update request source This bit is set and cleared by software to select the UEV event sources. Counter overflow/underflow Setting the UG bit Update generation through the slave mode controller

pub fn opm(&self) -> OPM_R

Bit 3 - One pulse mode

pub fn dir(&self) -> DIR_R

Bit 4 - Direction Note: This bit is read only when the timer is configured in Center-aligned mode or Encoder mode.

pub fn cms(&self) -> CMS_R

Bits 5:6 - Center-aligned mode selection Note: Switch from edge-aligned mode to center-aligned mode as long as the counter is enabled (CEN=1) is not allowed

pub fn arpe(&self) -> ARPE_R

Bit 7 - Auto-reload preload enable

pub fn ckd(&self) -> CKD_R

Bits 8:9 - Clock division This bit-field indicates the division ratio between the timer clock (CK_INT) frequency and the dead-time and sampling clock (tDTS)used by the dead-time generators and the digital filters (ETR, TIx): Note: tDTS = 1/fDTS, tCK_INT = 1/fCK_INT.

pub fn uifremap(&self) -> UIFREMAP_R

Bit 11 - UIF status bit remapping

Methods from Deref<Target = R<CR1_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CR1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CR1_SPEC>> for R

fn from(reader: R<CR1_SPEC>) -> Self

Converts to this type from the input type.