Struct stm32g0::stm32g0c1::aes::dinr::W

pub struct W(_);

Register DINR writer

Implementations

impl W

pub fn din(&mut self) -> DIN_W<'_, 0>

Bits 0:31 - Input data word A four-fold sequential write to this bitfield during the input phase results in writing a complete 128-bit block of input data to the AES peripheral. From the first to the fourth write, the corresponding data weights are [127:96], [95:64], [63:32], and [31:0]. Upon each write, the data from the 32-bit input buffer are handled by the data swap block according to the DATATYPE[1:0] bitfield, then written into the AES core 128-bit input buffer. The data signification of the input data block depends on the AES operating mode: - Mode 1 (encryption): plaintext - Mode 2 (key derivation): the bitfield is not used (AES_KEYRx registers used for input) - Mode 3 (decryption) and Mode 4 (key derivation then single decryption): ciphertext The data swap operation is described in page 499.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<DINR_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<DINR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<DINR_SPEC>> for W

fn from(writer: W<DINR_SPEC>) -> Self

Converts to this type from the input type.