Struct stm32g0::stm32g0c1::tim2::sr::CC1IF_R

pub struct CC1IF_R(_);

Field CC1IF reader - Capture/compare 1 interrupt flag This flag is set by hardware. It is cleared by software (input capture or output compare mode) or by reading the TIMx_CCR1 register (input capture mode only). If channel CC1 is configured as output: this flag is set when the content of the counter TIMx_CNT matches the content of the TIMx_CCR1 register. When the content of TIMx_CCR1 is greater than the content of TIMx_ARR, the CC1IF bit goes high on the counter overflow (in up-counting and up/down-counting modes) or underflow (in down-counting mode). There are 3 possible options for flag setting in center-aligned mode, refer to the CMS bits in the TIMx_CR1 register for the full description. If channel CC1 is configured as input: this bit is set when counter value has been captured in TIMx_CCR1 register (an edge has been detected on IC1, as per the edge sensitivity defined with the CC1P and CC1NP bits setting, in TIMx_CCER).

Implementations

impl CC1IF_R

pub fn variant(&self) -> CC1IF_A

Get enumerated values variant

pub fn is_b_0x0(&self) -> bool

Checks if the value of the field is B_0X0

pub fn is_b_0x1(&self) -> bool

Checks if the value of the field is B_0X1

Methods from Deref<Target = FieldReader<bool, CC1IF_A>>

pub fn bits(&self) -> U

Reads raw bits from field.

pub fn bit(&self) -> bool

Value of the field as raw bits.

pub fn bit_is_clear(&self) -> bool

Returns true if the bit is clear (0).

pub fn bit_is_set(&self) -> bool

Returns true if the bit is set (1).

Trait Implementations

impl Deref for CC1IF_R

type Target = FieldReader<bool, CC1IF_A>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.