Struct stm32g0::stm32g0c1::lptim1::lptim_cr::CNTSTRT_W

pub struct CNTSTRT_W<'a> { /* fields omitted */ }

Field CNTSTRT writer - Timer start in Continuous mode This bit is set by software and cleared by hardware. In case of software start (TRIGEN[1:0] = ’00’), setting this bit starts the LPTIM in Continuous mode. If the software start is disabled (TRIGEN[1:0] different than ’00’), setting this bit starts the timer in Continuous mode as soon as an external trigger is detected. If this bit is set when a single pulse mode counting is ongoing, then the timer will not stop at the next match between the LPTIM_ARR and LPTIM_CNT registers and the LPTIM counter keeps counting in Continuous mode. This bit can be set only when the LPTIM is enabled. It will be automatically reset by hardware.

Implementations

impl<'a> CNTSTRT_W<'a>

pub fn set_bit(self) -> &'a mut W

Sets the field bit

pub fn clear_bit(self) -> &'a mut W

Clears the field bit

pub fn bit(self, value: bool) -> &'a mut W

Writes raw bits to the field