Struct stm32g0::stm32g0b0::usart1::isr_fifo_enabled::LBDF_R

pub struct LBDF_R(_);

Field LBDF reader - LIN break detection flag This bit is set by hardware when the LIN break is detected. It is cleared by software, by writing 1 to the LBDCF in the USART_ICR. An interrupt is generated if LBDIE = 1 in the USART_CR2 register. Note: If the USART does not support LIN mode, this bit is reserved and kept at reset value. Refer to .

Implementations

impl LBDF_R

pub fn variant(&self) -> LBDF_A

Get enumerated values variant

pub fn is_b_0x0(&self) -> bool

Checks if the value of the field is B_0X0

pub fn is_b_0x1(&self) -> bool

Checks if the value of the field is B_0X1

Methods from Deref<Target = FieldReader<bool, LBDF_A>>

pub fn bits(&self) -> U

Reads raw bits from field.

pub fn bit(&self) -> bool

Value of the field as raw bits.

pub fn bit_is_clear(&self) -> bool

Returns true if the bit is clear (0).

pub fn bit_is_set(&self) -> bool

Returns true if the bit is set (1).

Trait Implementations

impl Deref for LBDF_R

type Target = FieldReader<bool, LBDF_A>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.