[−][src]Struct stm32f3::stm32f373::i2c1::cr1::W
Value to write to the register
Methods
impl W
[src]
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn pe(&mut self) -> _PEW
[src]
Bit 0 - Peripheral enable
pub fn txie(&mut self) -> _TXIEW
[src]
Bit 1 - TX Interrupt enable
pub fn rxie(&mut self) -> _RXIEW
[src]
Bit 2 - RX Interrupt enable
pub fn addrie(&mut self) -> _ADDRIEW
[src]
Bit 3 - Address match interrupt enable (slave only)
pub fn nackie(&mut self) -> _NACKIEW
[src]
Bit 4 - Not acknowledge received interrupt enable
pub fn stopie(&mut self) -> _STOPIEW
[src]
Bit 5 - STOP detection Interrupt enable
pub fn tcie(&mut self) -> _TCIEW
[src]
Bit 6 - Transfer Complete interrupt enable
pub fn errie(&mut self) -> _ERRIEW
[src]
Bit 7 - Error interrupts enable
pub fn dnf(&mut self) -> _DNFW
[src]
Bits 8:11 - Digital noise filter
pub fn anfoff(&mut self) -> _ANFOFFW
[src]
Bit 12 - Analog noise filter OFF
pub fn swrst(&mut self) -> _SWRSTW
[src]
Bit 13 - Software reset
pub fn txdmaen(&mut self) -> _TXDMAENW
[src]
Bit 14 - DMA transmission requests enable
pub fn rxdmaen(&mut self) -> _RXDMAENW
[src]
Bit 15 - DMA reception requests enable
pub fn sbc(&mut self) -> _SBCW
[src]
Bit 16 - Slave byte control
pub fn nostretch(&mut self) -> _NOSTRETCHW
[src]
Bit 17 - Clock stretching disable
pub fn wupen(&mut self) -> _WUPENW
[src]
Bit 18 - Wakeup from STOP enable
pub fn gcen(&mut self) -> _GCENW
[src]
Bit 19 - General call enable
pub fn smbhen(&mut self) -> _SMBHENW
[src]
Bit 20 - SMBus Host address enable
pub fn smbden(&mut self) -> _SMBDENW
[src]
Bit 21 - SMBus Device Default address enable
pub fn alerten(&mut self) -> _ALERTENW
[src]
Bit 22 - SMBUS alert enable
pub fn pecen(&mut self) -> _PECENW
[src]
Bit 23 - PEC enable
Auto Trait Implementations
Blanket Implementations
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> From<T> for T
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same<T> for T
type Output = T
Should always be Self