Enum stm32_hal2::pac::tim12::ccmr1_output::OC2M_A

#[repr(u8)]
pub enum OC2M_A {
    Frozen = 0,
    ActiveOnMatch = 1,
    InactiveOnMatch = 2,
    Toggle = 3,
    ForceInactive = 4,
    ForceActive = 5,
    PwmMode1 = 6,
    PwmMode2 = 7,
}

OC1M

Value on reset: 0

Variants

Frozen = 0

0: The comparison between the output compare register TIMx_CCRy and the counter TIMx_CNT has no effect on the outputs / OpmMode1: Retriggerable OPM mode 1 - In up-counting mode, the channel is active until a trigger event is detected (on TRGI signal). In down-counting mode, the channel is inactive

ActiveOnMatch = 1

1: Set channel to active level on match. OCyREF signal is forced high when the counter matches the capture/compare register / OpmMode2: Inversely to OpmMode1

InactiveOnMatch = 2

2: Set channel to inactive level on match. OCyREF signal is forced low when the counter matches the capture/compare register / Reserved

Toggle = 3

3: OCyREF toggles when TIMx_CNT=TIMx_CCRy / Reserved

ForceInactive = 4

4: OCyREF is forced low / CombinedPwmMode1: OCyREF has the same behavior as in PWM mode 1. OCyREFC is the logical OR between OC1REF and OC2REF

ForceActive = 5

5: OCyREF is forced high / CombinedPwmMode2: OCyREF has the same behavior as in PWM mode 2. OCyREFC is the logical AND between OC1REF and OC2REF

PwmMode1 = 6

6: In upcounting, channel is active as long as TIMx_CNT<TIMx_CCRy else inactive. In downcounting, channel is inactive as long as TIMx_CNT>TIMx_CCRy else active / Reserved

PwmMode2 = 7

7: Inversely to PwmMode1 / Reserved

Trait Implementations

impl Clone for OC1M_A

fn clone(&self) -> OC1M_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for OC1M_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl PartialEq for OC1M_A

fn eq(&self, other: &OC1M_A) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for OC1M_A

impl StructuralPartialEq for OC1M_A