Struct stm32_hal2::pac::opamp::opamp2_csr::W

pub struct W(/* private fields */);

Register OPAMP2_CSR writer

Implementations

impl W

pub fn opaen(&mut self) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 0>

Bit 0 - Operational amplifier Enable

pub fn force_vp( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 1>

Bit 1 - Force internal reference on VP (reserved for test)

pub fn vm_sel( &mut self ) -> FieldWriterRaw<'_, u32, OPAMP2_CSR_SPEC, u8, u8, Unsafe, 2, 5>

Bits 5:6 - Inverting input selection

pub fn opahsm( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 8>

Bit 8 - Operational amplifier high-speed mode

pub fn calon( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 11>

Bit 11 - Calibration mode enabled

pub fn calsel( &mut self ) -> FieldWriterRaw<'_, u32, OPAMP2_CSR_SPEC, u8, u8, Unsafe, 2, 12>

Bits 12:13 - Calibration selection

pub fn pga_gain( &mut self ) -> FieldWriterRaw<'_, u32, OPAMP2_CSR_SPEC, u8, u8, Unsafe, 4, 14>

Bits 14:17 - Operational amplifier Programmable amplifier gain value

pub fn usertrim( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 18>

Bit 18 - User trimming enable

pub fn tstref( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 29>

Bit 29 - OPAMP calibration reference voltage output control (reserved for test)

pub fn calout( &mut self ) -> BitWriterRaw<'_, u32, OPAMP2_CSR_SPEC, bool, BitM, 30>

Bit 30 - Operational amplifier calibration output

pub unsafe fn bits(&mut self, bits: u32) -> &mut W

Writes raw bits to the register.

Methods from Deref<Target = W<OPAMP2_CSR_SPEC>>

pub unsafe fn bits(&mut self, bits: <REG as RegisterSpec>::Ux) -> &mut W<REG>

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<OPAMP2_CSR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<W as Deref>::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut <W as Deref>::Target

Mutably dereferences the value.

impl From<W<OPAMP2_CSR_SPEC>> for W

fn from(writer: W<OPAMP2_CSR_SPEC>) -> W

Converts to this type from the input type.