Struct stm32_hal2::pac::mdma::ch::cr::R

pub struct R(_);

Register CR reader

Implementations

impl R

pub fn en(&self) -> BitReaderRaw<bool>

Bit 0 - channel enable

pub fn teie(&self) -> BitReaderRaw<bool>

Bit 1 - Transfer error interrupt enable This bit is set and cleared by software.

pub fn ctcie(&self) -> BitReaderRaw<bool>

Bit 2 - Channel Transfer Complete interrupt enable This bit is set and cleared by software.

pub fn brtie(&self) -> BitReaderRaw<bool>

Bit 3 - Block Repeat transfer interrupt enable This bit is set and cleared by software.

pub fn btie(&self) -> BitReaderRaw<bool>

Bit 4 - Block Transfer interrupt enable This bit is set and cleared by software.

pub fn tcie(&self) -> BitReaderRaw<bool>

Bit 5 - buffer Transfer Complete interrupt enable This bit is set and cleared by software.

pub fn pl(&self) -> FieldReaderRaw<u8, u8>

Bits 6:7 - Priority level These bits are set and cleared by software. These bits are protected and can be written only if EN is 0.

pub fn bex(&self) -> BitReaderRaw<bool>

Bit 12 - byte Endianness exchange

pub fn hex(&self) -> BitReaderRaw<bool>

Bit 13 - Half word Endianes exchange

pub fn wex(&self) -> BitReaderRaw<bool>

Bit 14 - Word Endianness exchange

Methods from Deref<Target = R<CR_SPEC>>

pub fn bits(&self) -> <REG as RegisterSpec>::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &<R as Deref>::Target

Dereferences the value.

impl From<R<CR_SPEC>> for R

fn from(reader: R<CR_SPEC>) -> R

Converts to this type from the input type.