Module stm32_hal2::gpio

This module provides functionality for General Purpose Input and Output (GPIO) pins, including all GPIOx register functions. It also configures GPIO interrupts using SYSCFG and EXTI registers as appropriate.

Structs

Pin

Represents a single GPIO pin. Allows configuration, and reading/setting state.

Enums

CfgLock

Values for GPIOx_LCKR.

Edge

The pulse edge used to trigger interrupts. Either rising, falling, or either.

OutputSpeed

Values for GPIOx_OSPEEDR. This configures I/O output speed. See the user manual for your MCU for what speeds these are. Note that Fast speed (0b10) is not available on all STM32 families.

OutputType

Values for GPIOx_OTYPER.

PinMode

Values for GPIOx_MODER. Sets pin to input, output, and other functionality.

PinState

Values for GPIOx_IDR and GPIOx_ODR.

Port

GPIO port letter

Pull

Values for GPIOx_PUPDR. Sets if the pin uses the internal pull-up or pull-down

ResetState

Values for GPIOx_BRR.

Functions

clear_exti_interrupt

Clear an EXTI interrupt, lines 0 - 15. Note that this function currently doesn’t support higher extis, but will work for all GPIO interrupts.

is_high

Check if a pin’s input voltage is high. Reads from the IDR register. Does not require a Pin struct.

is_low

Check if a pin’s input voltage is low. Reads from the IDR register. Does not require a Pin struct.

set_high

Set a pin’s output voltage to high. Sets the BSRR register. Atomic. Does not require a Pin struct.

set_low

Set a pin’s output voltage to low. Sets the BSRR register. Atomic. Does not require a Pin struct.

set_state

Set a pin state (ie set high or low output voltage level). See also set_high() and set_low(). Sets the BSRR register. Atomic. Does not require a Pin struct.

write_dma^⚠

Write a series of words to the BSRR (atomic output) register. Note that these are direct writes to the full, 2-sided register - not a series of low/high values.